Week 9

This week we focused on finishing up our whole project. We completed the powerpoint presentation and began organizing how we would present our design in week ten. We also corrected our final design report based on suggestions from our lab advisors.

Week 8

We calculated the volume of our ear model, which came out to be 19 cu cm. Real ears aren't made of ABS plastic, but rather other materials. We can use the density of these other materials to find the mass of our ear should it be printed using these other materials instead of ABS plastic.

We can then compare this mass to the mass of a real ear to see what materials would produce an ear closest in mass/density to the real thing.

An artificial ear would need to be attached using surgical procedures, which can come with risks of infection and rejection. Choosing the right materials is crucial in reducing these risks.



We also began designing the powerpoint we will use for the presentation.

Week 7

Sending the ear out for printing required some modifications in which the model had to be smoothed numerous times. Also, since Maya cannot export .stl files (which are needed in order to 3D print) the model had to be exported using the program Rhinoceros 3D.

 

Our artificial ear design was printed using the 3D printer. Our design was successfully printed without any malfunctions, so we do not have to reprint it. The material used to print the ear was ABS plastic. The ear is lightweight and durable.

Week 6

This week, we finished constructing the 3D model of the ear on the Maya software. The file has been converted to a ".stl" format and sent to the 3D printer at Drexel University. Now the focus is on making sure the dimensions of the ear are appropriate for picking up sounds. To ensure that the ear will be able to work in real life, we are looking into a formula relating sound pressure and volume of the outer ear. Hopefully, this will be done by next week.

On a side note, we are preparing our rough draft of the final report, which is due next week.